Digital Scrub Function - Fostex UR-2 Owner's Manual

Power on play function
By setting the "Power On Play" menu item in the
PLAY SETUP menu of the MENU mode to "On"
before turning off the power, the unit automati-
cally start playback of files in the current stor-
age device next time you turn on the power.
By default, the "Power On Play" menu
<Memo>:
item is set to "Off". See "PLAY SETUP menu de-
tails" on page 58 for details about the "Power
On Play" menu item.
<Memo>: After turning on the power when the
"Power On Play" menu item is set to "On", the
unit starts playback in the playback mode you
set before turning off the power. (Note that the
power on play function is not active in the
"MEMORY play mode" or "TIMER play mode".)
To use a timer for power-on play, follow
<Note>:
the procedure below.
1) Turn off the unit.
2) Connect a timer to the unit.
3) Set the timer appropriately.
4) Press the [POWER] switch to "On" (up)
position.
When more then one folder exists on the
<Note>:
current storage, the power on play function does
not work. The unit brings up the folder selec-
tion screen and stops after it is turned on (see
page 29).

Digital scrub function

While the unit is stopped, pressing the [PLAY]
key while holding down the [STOP] key enters
the scrub mode, and the display changes to show
the screen as below.
REC RDY
Y
UR-2
STEREO RACK MEMORY RECORDER
<Digital scrub screen>
The " " on the screen above indicates the cur-
rent position. While this screen is shown, you can
scrub forward or backward in approximately five
to ten millisecond steps using the [MENU] dial.
After performing digital scrub, pressing the [EN-
TER] key exits the scrub mode.
-55-
Model UR-2 <Playback>
[MENU] dial/[ENTER] key
MENU / ENTER
EXIT FILE/CURSOR
MRGN RST PREV CUE NEXT
REC STOP PLAY REW F FWD
ABS 0
REC END
[PLAY] key
[STOP] key
CUE/LOCATE MIC IN
TIME EDIT MIC SET
MIN MAX MIN M
INPUT LEVEL MIC GAIN