Upgrading The; Executing Upgrade File - Fostex UR-2 Owner's Manual

Upgrading the UR-2
To upgrade the UR-2, download the upgrade file from the Fostex website (http://www.fostex.com) to
your computer and copy it to an SD card or USB memory using either of the following two method, then
execute the upgrade file (check the Fostex website about the latest software information of the UR-2).
Connect the UR-2 to your computer
<Method 1>:
using the "USB to PC" menu of the MENU mode
and copy the upgrade file downloaded from the
computer to the SD card set to the UR-2 (you
cannot use a USB memory while the UR-2 is con-
nected to the computer). See "File transfer be-
tween the UR-2 and your computer" for details
about file transfer between the UR-2 and your
computer on page 65.
SHIFT
POWER
AUTO PLAY
PHONES
USB PC USB HOST
EJECT
(KYBD ONLY)
READY
SD-1 SD-2
MIN MAX
<Method 2>: Set a USB memory or SD card (di-
rectly or via a card adaptor) to your computer
and copy the upgrade file from the computer to
the USB memory or SD card.
Executing software upgrade
In the following procedure, it is assumed that only
a storage device (SD card or USB memory) in
which the upgrade file with the ".mot" extension
is copied using either of two methods above is
set to the unit.
(1) Turn on the UR-2.
The UR-2 starts up.
After reading the upgrade file, the following
screen is shown.
(2) Press the [ENTER] key.
The unit starts software upgrade and the
progress is shown on the screen.
PLAY MENU / ENTER PHANTOM
FILE/CURSOR CUE/LOCATE
MODE TIME REC RDY EXIT MIC IN
EDIT REPEAT MRGN RST PREV CUE NEXT TIME EDIT MIC SET
REC STOP PLAY REW F FWD
FILE SEL DISPLAY
UR-2
MIN MAX MIN MAX
STRG SEL STEREO RACK MEMORY RECORDER
ABS 0 INPUT LEVEL MIC GAIN MIC IN
REC END
LOCK
Model UR-2 <Upgrading the UR-2>
After finishing upgrade, the display briefly
shows "Complete" and returns to the Home
screen.
<Note>:
grade. Do not turn off the power during
upgrade. If you do so, the unit may not
start up.
(3) After finishing upgrade, eject the storage
device, then turn off and on the unit.
If required, perform "SYS. initial memory" in
the SYSTEM SETUP menu of the MENU mode
(see page 81).
<Note>:
ejecting the storage device, the UR-2 rec-
ognizes the software upgrade file and the
screen shown in the procedure (1) is dis-
played again. In this case, the [EXIT] key
to cancel.
<Note>:
nect the unit to your computer or mount
the SD card or USB memory directly to
the computer, and delete the file by using
the computer.
-69-
All keys are disabled during up-
If you turn on the unit without
To delete the upgrade file, con-