Brother HL-4150CDN User Manual page 208

Hide thumbs Also See for HL-4150CDN:
Table of Contents

Advertisement

Appendix
When CODE 39 is chosen with the parameter 't0' or 'T0'
Forty three characters '0' to '9', 'A' to 'Z', '-', ' . ', ' (space)', '$', ' / ', '+', and '%' can be accepted as bar code
data. Other characters will cause a data error. The number of characters for bar codes is not limited. The
bar code data automatically starts and ends with an asterisk ' * ' (start character and stop character). If the
received data has an asterisk ' * ' at the beginning or end, the asterisk is regarded as a start character or
stop character.
When Interleaved 2 of 5 is selected with the parameter 't1' or 'T1':
Ten numerical characters '0' to '9' can be accepted as bar code data. Other characters cause a data error.
The number of characters for bar codes is not limited. This mode of bar codes needs even characters. If
the bar code data has odd characters, '0' is automatically added to the end of the bar code data.
When FIM (US-Post Net) is selected with the parameter 't3' or 'T3'
Characters 'A' to 'D' are valid and one digit of data can be printed. Upper-case and lower-case alphabet
characters can be accepted.
When Post Net (US-Post Net) is selected with the parameter 't4' or 'T4'
Numbers '0' to '9' can be data and it must end with a check digit. '?' can be used instead of the check digit.
When EAN 8, EAN 13, or UPC A is selected with the parameter 't5' or 'T5'
Ten numbers '0' to '9' can be accepted as bar code data. The number of characters for bar codes is limited
as follows:
EAN 8: Total 8 digits (7 digits + 1 check digit)
EAN 13: Total 13 digits (12 digits + 1 check digit)
UPC A: Total 12 digits (11 digits + 1 check digit)
A number of characters other than those stated above will cause a data error that results in the bar code
data being printed as normal print data. If the check digit is not correct, the machine decides the correct
check digit automatically so that the correct bar code data will be printed. When EAN13 is selected, adding
'+' and a two-digit or five-digit number after the data can create an add-on code.
When UPC-E is selected with the parameter 't6' or 'T6':
The numbers '0' to '9' can be accepted as bar code data.
1 2
(standard format) The first character must be '0' and the data must end with a check digit.
Eight digits
Total eight digits = '0' plus 6 digits plus 1 check digit.
2
The first character and the last check digit are removed from the eight digit data.
Six digits
1
'?' can be used instead of a check digit.
2
Adding '+' and two-digit or five-digit number after the data creates an add-on code.
When Codebar is chosen with the parameter 't9' or 'T9'
Characters '0' to '9', '-', ' . ', '$', '/', '+', ' : ' can be printed. Characters 'A' to 'D' can be printed as a start-stop
code, which can be upper case or lower case. If there is no start-stop code, errors will happen. A check
digit cannot be added and using '?' causes errors.
A
185

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hl-4570cdwHl-4570cdwt4570cdw(tHl-4140cn

Table of Contents