Troubleshooting - Broil King P3S-1 Owner's Manual

TROUBLESHOOTING

Although the manufacturer has attempted to ensure that your grill will operate properly and satisfactorily, some-
times problems do arise. The following troubleshooting guide lists several possible problems and their probable
cause and solution.
Problem
Burner will not light.
Inadequate grill tempera-
ture.
Flames blow out.
Yellow flames.
Page 22
Cause
Gas injector not inserted in venturi
tube.
Clogged gas injector.
Obstruction in gas line.
Spider webs in venturi tubes.
Misalignment of collector box and
burner.
Out of gas
Dead battery.
Poor combustion.
Misalignment of venturi tube and gas
injector.
Inadequate gas pressure.
Incorrect orifice/valve setting.
Cold grill.
Misalignment of burner tube and gas
injector.
Poor combustion.
Extreme wind.
Air shutter improperly set.
Spider webs in venturi tubes.
Seasoning salts on burner.
Oil film on burner.
Solution
Realign/engage gas injector with the
venturi tube.
Remove gas injector from gas control
assembly and clean.
For propane models, ensure gas valve
on cylinder is OFF. Remove flexible
hose and blow out any debris.
Clean venturi tubes. See Maintenance
Section.
Position electrode properly. Clean col-
lector box.
Refill LP gas cylinder. If natural model,
turn on gas at source.
Replace with AA Alkaline battery.
Adjust air shutter.
Realign/engage gas injector with the
venturi tube.
Contact gas supplier for assistance.
Refer to gas conversion instructions in
this manual.
Preheat grill at least 5 minutes on HI
with the grill lid closed.
Realign/engage gas injector with the
burner tube.
Adjust air shutter.
Turn or shield grill.
Open air shutter
Clean venturi tubes. See Maintenance
Section.
Clean by washing burner with mild
detergent.
Allow burner to operate on HI for 10-
15 minutes.
B101362-2-0610