Front Led Card Assembly - IBM 866631Y - Netfinity 7100 - 8666 Hardware Maintenance Manual

Front LED card assembly

Review the information in "Before you begin" on page 43.
1. Power-off the server, if it is on.
2. Disconnect the power cord for each power source from the electrical outlet.
3. Remove the top cover (see "Removing the top cover" on page 45).
4. Disconnect the cable to the diagnostic switch card.
5. Remove the two retaining screws that secure the board in place.
6. Remove and replace the board.
1
Retaining screws
2
Front LED card assembly
Attention: The presence of ac standby power might result in damage to the
hardware unless you disconnect the power cord for each power source from
the electrical outlet.
FRU information (service only)
111