Installing A Hot-Swap Power Supply - IBM 866631Y - Netfinity 7100 - 8666 Hardware Maintenance Manual

Installing a hot-swap power supply

Before you continue with the power supply-installation procedure, review the
following.
Notes:
1. During normal operation, each power supply bay must have either a power
2. If you have a rack model, before you install a power supply in the right-most
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any component
that has this label attached. There are no serviceable parts inside these
components. If you suspect a problem with one of these parts, contact a service
technician.
Before you continue with the power supply-installation procedure, review the
following.
Before you begin:
v Read "Safety information" on page 152.
v Review the information in "Before you begin" on page 43.
v Read the documentation that comes with the option.
60
Hardware Maintenance Manual: Netfinity 7100 – Type 8666
supply or filler panel installed for proper cooling.
power supply bay, you must disconnect the cable-management arm. You can
connect the cable-management arm after installing the power supply.