Completing The Installation; Installing The Bezel - IBM 8486 - eServer xSeries 100 User Manual

Completing the installation

To complete the installation, you must reinstall the bezel, reinstall the side cover,
connect all the cables and, for certain options, run the Configuration/Setup Utility
program. Follow the instructions in this section.

Installing the bezel

To replace the bezel, complete the following steps:
1. Insert the two alignment tabs at the top of the bezel into the bezel retention
2. Push the bottom of the bezel toward the server until the bezel snaps into place.
34
xSeries 100 Type 8486: User's Guide
slots at the top of the chassis.