Rear View - IBM 8486 - eServer xSeries 100 User Manual

Power-on LED

Rear view

The following illustration shows the connectors on the rear of the server.
Power-cord connector
Power supply error LED
AC power LED
Mouse connector
Keyboard connector
Serial 1 connector
When this LED is lit, it indicates that the server is turned on. When this LED
is off, it indicates that ac power is not present, or the power supply or the
LED itself has failed.
Note: If this LED is off, it does not mean that there is no electrical power in
the server. The LED might be burned out. To remove all electrical power
from the server, you must disconnect the power cord from the electrical
outlet.
Connect the power cord to this connector.
When this amber LED is lit, it indicates that a power supply error has
occurred.
When this green LED is lit, it indicates that the server is connected to an ac
power source.
Connect a mouse or other PS/2
Connect a PS/2 keyboard to this connector.
Connect a 9-pin serial device to this connector.
®
device to this connector.
Chapter 1. The xSeries 100 Type 8486 server
9