IBM 8486 - eServer xSeries 100 User Manual page 40

10. Connect one end of the signal cable into the back of the drive and make sure
11. Route the signal cable so that it does not block the airflow to the rear of the
12. Connect the power cable to the back of the drive. The connectors are keyed
If you have other options to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 34.
28
xSeries 100 Type 8486: User's Guide
4. Move the drive cage release lever to the unlocked position and gently pull the
drive cage out of the drive cage slot on the chassis and set it aside.
Screws
5. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
Note: If the hard disk drive comes attached to a drive tray, remove the drive
from the drive tray before you install the drive in the drive bay.
6. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
7. Align the drive assembly with the guide rails in the bay (with the connector end
of the drive facing you).
8. Gently slide the drive assembly into the drive bay as far as it will go.
9. Attach the hard disk drive to the drive cage with the four screws.
that the other end of the cable is connected into the connector on the system
board. See "Power and signal cables for internal drives" on page 29 for
additional information about cabling drives and "System-board internal
connectors" on page 14 for the location of the SATA connectors.
drives or over the microprocessor and DIMMs.
and can be inserted only one way.
Locking lever