Table of Contents
Advertisement
Chapter 3
Getting Started
This chapter provides instructions on setting up your IDXPERT
Refer to the following chapter for details on how to use the keypad and menu.
Setting up the printer
Follow these steps to setup your printer prior to creating your first label.
Step 1.
Install batteries or connect to power
To insert six AA alkaline batteries (not included),
1. Remove the battery cover located on the backside of the printer.
2. Install the batteries as shown. See inside the battery compartment for the battery-positioning grid.
3. Close the battery compartment.
ABC Keypad Version
Note: You can print up to 650 labels between battery changes.
The IDXPERT
printer can also be powered by use of an A/C adaptor. See the section on
TM
Connections on page 5.
Step 2.
Replace material cartridge
Note: Make sure to cut off any excess label material before removing an existing
cartridge.
Your printer ships with a cartridge installed. Follow these instructions to replace the existing
cartridge.
1. Turn the locking lever down to unlock the
cartridge.
2. Locate the cartridge release button on the
backside of the printer and push firmly to
eject cartridge.
3. Remove the existing cartridge.
4. Install the new cartridge as shown.
5. Turn the locking lever up to lock both the
cartridge and printhead.
Step 3.
Turn the printer ON
Press the POWER key.
User's Manual
Battery
Cover
Keyboard Layout Version
printer and creating a basic label.
TM
Locking Lever
7
Advertisement
Table of Contents
