System Specifications - 3Com 3CBLSF26PWRH User Manual

Duplex
Module Active
PoE Power (Only supported by
Baseline Switch 2426-PWR Plus)

System Specifications

Table 1-3 contains the system specifications of the Switch.
Table 1-3 System specifications of the Switch.
Specification
Physical dimensions
(H×W×D)
Weight
Console port
Ethernet port
Gigabit Combo port
AC Input voltage
Power consumption (full
load)
Operating temperature
Storage temperature
LED
OFF
Yellow
10/100/1000BA
SE-T port
OFF
Green
SFP port
OFF
Green
OFF
2226-SFP
44 mm×440 mm×170
mm
1.6 kg
1
24
2
Rated voltage range:
100–240V AC, 50/60
Hz
17 W
0°C to 40°C (32°F to 104°F)
–40°C to +70°C (–40°F to 158°F)
Status
The link has not been established, either
nothing is connected to the port, or there is a
problem:
Check that the attached device is powered
on.
Check that the cable or fiber is the correct
type and is not faulty.
For fiber connections, ensure that the
receive (RX) and transmit (TX) cable
connectors are not swapped.
If these checks do not identify the cause of
the problem, it may be that the unit or the
device connected to the port is faulty. Contact
your supplier for further advice.
The port is in full duplex mode.
The port is not connected, or is in half duplex
mode.
The SFP module is inserted.
The SFP module is not inserted or is not
recognized.
The port is supplying power to the device
connected to it.
The port is not supply power to the device
connected to it or not connected.
2426-PWR
44 mm×440
mm×238 mm
3.2 kg
1
24 (Each port can
provide a power
supply of 25 W)
2
Rated voltage range:
100–240V AC, 50/60
Hz
205 W
1-4
Description
2250-SFP
44 mm×440 mm×238
mm
2.9 kg
1
48
2
Rated voltage range:
100–240V AC, 50/60
Hz
26 W