This function should be activated if
traditional "big box" detergents are
used. For the first 10 seconds of the
Cottons main wash cycle water flows
in through compartment i.
Compartment j may sometimes not
be able to hold the total amount of de-
tergent required when:
- the water is very hard (over 3.8 mmol/
l, water hardness level IV) and
- the washing is heavily soiled.
In this case compartment i can be
used to flush in the extra detergent for
the main wash.
Before the "Activating the i compart-
ment" programmable function can be
selected you must first select program-
ming mode.
A The machine must be switched off
and the drum door closed. The
programme selector must point to
Finish .
B Press the additional option buttons
Short and Water plus at the same
time and hold pressed in and:
C . . . switch the machine on with the
I-ON/0-OFF-button.
D Let go of all these buttons.
The indicator light Main wash flashes in
the sequence display.
34
i
To select the "Activating the i com-
partment" programmable function turn
the programme selector to - Spin ***.
To activate "Activating the i compart-
ment" press the START button once.
The Rinses light comes on in the se-
quence display.
To store the "Activating the i compart-
ment" programmable function in the
memory SWITCH the machine OFF with
the I-ON/0-OFF button.
The "Activating the i compartment"
programmable function is now stored in
the machine's memory.
To deactivate the use of Compartment
i repeat the procedure given above
from point A as far as the *** shown
above. Press the START button and the
Rinses indicator light will go out. The
function is deactivated. Store in mem-
ory by pressing the I-ON/0-OFF button.