Activating The I Compartment - Miele Premier Novo Operating Instructions Manual

Activating the i compartment

This function should be activated if
traditional "big box" detergents are
used. For the first 10 seconds of the
main wash cycle water flows in
through compartment i.
Compartment j may sometimes not
be able to hold the total amount of
detergent required when:
- the water is very hard (over 3.8 mmol/l,
water hardness level IV) and
- the washing is heavily soiled.
In this case compartment i can be
used to flush in the extra detergent for
the main wash.
Before the "Activating the i compart-
ment" programmable function can be
selected you must first select pro-
gramming mode.
Selecting programming mode
1
The machine must be switched off
and the drum door closed. The pro-
gramme selector must point to "Fin-
ish".
2
Press the additional option buttons
"Short" and "Water plus" at the same
time and hold pressed in and:
3
. . . switch the machine on with the
"I-ON/0-OFF"-button.
4
Let go of all these buttons.
The indicator light "Main wash" flashes
in the sequence display.
Programmable functions
Selecting the programmable function
To select the "Activating the i com-
partment" programmable function turn
the programme selector to – Spin ***.
Activating
To activate "Activating the i compart-
ment" press the "START" button once.
The "Rinses" light comes on in the se-
quence display.
Storing in memory
To store the "Activating the i compart-
ment" programmable function in the
memory SWITCH the machine OFF with
the "I-On/0-OFF" button.
The "Activating the i compartment"
programmable function is now stored in
the machine's memory.
Deactivating
To deactivate the use of Compartment
i repeat the procedure given above
1
from point as far as the *** shown
above. Press the START button and the
"Rinses" indicator light will go out. The
function is deactivated. Store in mem-
ory by pressing the I-On/0-Off button.
33