Table of Contents
Advertisement
front Panel
1
1. InPutS 1 anD 2 (MIc/InSt 1 anD MIc/InSt 2)
These balanced inputs accept XLR or 1/4" connectors, and support mic,
line, and instrument level sources (including guitars).
2. InStruMent Button/LeD
Press when an instrument level source (such as a guitar) is connected to the
corresponding input (1 or 2). The button illuminates when activated.
3. +48V Button/LeD
Each of these buttons enables the phantom power to the corresponding
inputs pairs. Dynamic microphones do not require phantom power to
operate. Most condenser microphones do require phantom power to oper-
ate. If you are unsure about the phantom power requirements for your
microphone, consult your microphone's documentation or contact the
manufacturer. This switch should be OFF if you are connecting any line-
level source to the Mic/Inst or Mic Pre jacks.
4. DynaMIcS LeDS anD InPut LeVeL LeDS
The top three rows indicate what dynamics are active for each input. The
bottom three rows indicate signal presence (green) and level (yellow and
red) for each input.
5. fIrewIre
LeD
tM
Indicates when a FireWire
6. Power LeD
Indicates when the IO FW810S is turned on.
7. GaIn knoBS 1 anD 2
These knobs adjust the input gain levels for Mic/Inst 1 and Mic/Inst 2.
8. GaIn knoBS 3 – 8
These knobs adjust the input gain levels for Mic Pre 3 – 8 (the inputs
located on the back panel).
9. heaDPhone outPut Jack
Connect headphones here.
10. heaDPhone LeVeL knoB
Adjust headphone output signal level here.
11. MaIn outPutS LeVeL knoB
Adjust the main output signal level here.
2
3
7
TM
connection is present.
8
4
5
9
10 11
6
3
Advertisement
Table of Contents
