Set Up Cubase Le For Use With The Io Fw810S (Windows ) - Lexicon I-O|FW810S Owner's Manual

Set Up Cubase LE for Use with the IO FW810S
®
(Windows )
®
Make sure the included FireWire TM cable is connected between your
computer and FW810S, the Mixer is open, and the FW810S is turned on.
Start Cubase ® LE (from the Start menu under Lexicon ® ).
If you see the warning shown below, click OK.
Once you are in Cubase LE, go to Devices > Device Setup.
Under Devices, click on VST Audio System and select ASIO Lexicon IO
from the ASIO Driver pull-down menu if it is not already selected. Click on
Switch to switch the driver, then click OK in the Device Setup dialog. You
are now ready to begin recording using your FW810S and Cubase LE.
32