Set Up Cubase Le For Use With The Io Fw810S (Mac ) - Lexicon I-O|FW810S Owner's Manual

Set Up Cubase LE
(Mac )
®
Make sure the included FireWire
computer and FW810S, the Mixer is open, and the FW810S is turned on.
Open Cubase LE (located in the Applications folder), and go to Devices >
Device Setup as shown below.
Click VST Audio System, then select Lexicon IO as the ASIO Driver if it is
not already selected.
4. Cubase ® LE will now ask you if you would like to switch the driver. Select
Switch then OK.
Mac ® OS 10.4.x users only: After selecting Lexicon
Driver, you may need to verify that your device inputs are active. To do this,
follow these steps:
1. Select Device > VST Connections from the menu bar.
2. When the VST Connections panel appears, click the Inputs tab.
3. The box under the Audio Device column may say "Not Connected". If
it does, click in this box and select Lexicon IO to enable the FW810S
inputs.
4. Close the VST Connections window.
You are now ready to start recording with Cubase LE, described in the next
section, Using the IO FW810S.
for Use with the IO FW810S
®
TM cable is connected between your
FW810S as the ASIO
®
33