Rear Panel - Lexicon I-O|FW810S Owner's Manual

2 3
1
4

rear Panel

4 5 6
1. Power SwItch
Turn the IO FW810S on or off here.
2. Power Jack
Standard 3-pin IEC power connector. 100-240V, 50-60Hz automatic
switching to correct voltage range.
3. MIDI In anD out
The MIDI jacks provide MIDI input and MIDI output to and from your
computer. Connect your MIDI keyboards, sound modules, and external
controllers here.
4. S/PDIf In anD out
The S/PDIF in and out ports are unbalanced phono (RCA) connectors
that transmit and receive either a 16-bit or 24-bit two-channel audio
stream. S/PDIF ports may be found on many professional and consumer
CD and digital audio recorders. It is recommended to use 75-Ohm coaxial
cable for S/PDIF transfers and keep the cable length to a maximum of 10
meters to minimize interference and data dropout.
5. fIrewIre
tM
Connect FireWire
acting as Thru.
Note: When daisy chaining devices, connect other IO FW810S units only.
Do not connect other FireWire devices to the IO FW810S.
6. BaLanceD outS 1–8
These outputs support balanced TRS or unbalanced TS ¼" connections.
These outputs can be connected to a mixing board, power amplifier, pow-
ered studio monitors, recorder, or another line level input.
7. MaIn outPutS
These outputs support balanced TRS or unbalanced TS ¼" connections.
These outputs can be connected to a mixing board, power amplifier, pow-
ered studio monitors, recorder, or another line level input.
8. MIc/LIne InPutS 3–8
These balanced inputs accept XLR or 1/4" connectors, and support mic
and line level sources.
7
PortS
TM cables here. Either port can be used, with the other
8