System Settings; Failure Indication - Lancia Thesis Owner's Handbook Manual

To actuate central opening of the
windows and sunroof, keep the
remote control button B (fig. 25)
depressed for more than 2 seconds
after opening the doors: both the win-
dow regulators and the sunroof will be
actuated until they are fully opened or
until the button is released.
This function can be used to aerate
the passenger's compartment before
getting into the car parked in the sun.
IMPORTANT Do not lay the CID
device outside the car on the sunroof,
to avoid a fake identification of the
CID itself as if inside the car. It is rec-
ommend to carry about with you the
CID device (e.g. into a pocket).
Before and during auto-
matic actuation of the
window regulators and
sunroof, always make sure that
the passengers and the persons
standing near the car are not
exposed to the risk of injures that
may be caused either by the mov-
ing windows and sunroof or by
objects dragged or hit by the
same.
52

SYSTEM SETTINGS

The CONNECT enables to cus-
tomize certain functions of the
Keyless System recognition system,
through the settings that can be
selected on the CONNECT display.
The "central unlock" and "driver's
door unlock" functions of the central
locking can be set also for the
Keyless System and operate as fol-
lows:
– central unlock: all the car doors
are unlocked simultaneously and
access is possible through every door
– driver's door unlock: access is
possible through the driver's door
whereas the other doors remain
locked, thus preventing un-autho-
rized persons from getting into the
car. In this case, the led on the dri-
ver's door panel lights up (green
colour) whereas the leds on the other
doors remain off.
When "unlocking driver's door" is
set, it is anyhow possible to unlock all
the doors, to enable access to passen-
gers, by pushing button B (fig. 18) on
CID device or, after opening the dri-
ver's door, by pushing the central
unlock button existing on the door
panel.
The other recognition system set-
tings that can be enabled/disabled
are:
– automatic locking of doors and
boot.
As regards the setting of the recog-
nition system customizations, refer
to the CONNECT supplement.

FAILURE INDICATION

The presence of anomalies in the
Keyless System is indicated by the
lighting of symbol Y on the instru-
ment display, together with the mes-
sage "VEHICLE PROTECTION
SYSTEM FAULT".
IMPORTANT In case of fault, con-
tact your Lancia Dealership.