Installation/ Removal Of The Mexico - Becker Mexico 7948 Installation Manual

Installation Guide

Installation/ Removal of the Mexico

• Installation:
The Mexico features an integrated universal bracket for
DIN installation slots. An installation frame is not required.
The Mexico is inserted into the installation slot and secured with
the slides supplied.
To install, complete all electrical connections. Then push the Mex-
ico into the installation slot. Subsequently, insert slides into the
openings on the front of the Mexico as far as the first detent posi-
tion (Fig. A). Now lock the radio in by pulling on both slides as
shown in Fig. B. Subsequently, remove the slides.
The installation angle of the Mexico must not exceed 0° - 35°
(vertical). Only the enclosed bolts may be used for an attach-
ment from the rear.
• Removal:
To remove the Mexico, it must first be unlocked. To do this, push
in both slides as far as the second detent position as shown in Fig-
ure A . Then take hold of the Mexico on both sides and pull it out
(Fig. C). Next, remove the slides by pressing the springs on the
right and left sides of the Mexico. If the Mexico was previously
installed in another vehicle, it may be necessary to adjust the
springs on the unit before installationMexico. To adjust the
springs, insert slide as shown in Fig. D and subsequently adjust as
shown in Fig. E (Gently press slide in the direction of 1 while at
the same time moving the slide in the direction of 2).
16
A
B
C
D
2
E
1