Fitting The Chimney Section - Baumatic MG3 Instruction Manual

Fitting the chimney
IMPORTANT: The chimney sections are not supplied
with the appliance. You can purchase the chimney
sections (CQ1SS) from the Baumatic Spares
Department.
15) Take the fixing bracket (L) and place it between the two pencil
marks that you made in step 13
o Keeping the bracket in contact with the wall, use a pencil to
mark on the wall the anchoring holes that are cut out of the
bracket.
13) Take the two chimney
sections (G and H).
o Rest the bottom of
chimney section G on
the top of the hood. You
should take care to
position the tabs on the
chimney section into
the rear of the hood.
o Mark the side
measurement of both
sides of chimney section
G on the wall with a
pencil.
14) Lift chimney section H
upwards until it reaches
the ceiling. You must
ensure that it is
perpendicular to the hood.
o Mark the side
measurement of
both sides of
chimney section H
on the wall with a
pencil and then
remove chimney
section H.
26