Dynex DX-RCRT20-09 User Manual page 9

Features
Item
3 INPUT
4 DTV Audio
5 ENTER
6 MENU
7 VOL– / VOL+
8 SLEEP
9 CCD
10 GUIDE
11 EXIT
12 POWER
13 DISPLAY
14 TV/DTV
15 Number buttons
(0-9)
16 PICTURE
17 •
18 CH– / CH+
19 ZOOM
20 FAVORITE
21 CH.LIST
Button
Press this button to select the video input source. (TV, AV, [S-VIDEO],
COMPONENT)
Press to choose between different TV program languages when the
signal contains different languages.
Press to make or confirm selections in the on-screen display (OSD)
menus.
Press to open the OSD.
Press to decrease or increase the volume. In some cases, press this
button to change an OSD setting.
Press this button to set the TV to turn off after a preset amount of
time. To confirm the sleep time setting, press this button once and
the remaining time is momentarily displayed. To cancel sleep time,
press this button repeatedly until 0FF is displayed.
Press this button to select CCD mode.
Press this button to display the program guide for cable or satellite
TV.
Press this
Press this
Press this
Press this
Press these buttons to directly go to any channel.
Press this button to select the picture mode.
Press this button to select a digital TV sub-channel. For example, to
select channel 54, sub-channel 3, press 54, press •, press 3, then
press ENTER.
Press these buttons to change to a lower or higher numbered
channel set into memory. When the OSD is open, press to adjust
options and make selections.
Press this button, in 16:9 digital TV mode, to select the aspect ratio
of the picture.
Press this button to open the DTV favorites list.
Press this button to open the DTV channel list.
Description
button to exit the OSD.
button to turn the TV on. Press again to turn the TV off.
button to display channel status and signal information.
button to select analog (TV) or digital (DTV) TV mode.
9