Skipping Unwanted Channels - Dynex DX-RCRT20-09 User Manual

20” round tube tv
Table of Contents

Advertisement

Using your TV

Skipping unwanted channels

After saving channels into memory, you can eliminate unwanted channels from memory so
that only the channels you want to watch are selected with the CH+ or CH– buttons.
To delete a memorized analog channel:
1 Tune to the channel you want to delete.
2 Press MENU on the TV or remote control. The on-screen display (OSD) opens.
3 Press VOL+ or VOL– to select CHANNEL, then press CH –. The CHANNEL menu opens.
4 Press CH + or CH – to select SKIP, then press VOL+ or VOL– to select ON.
5 Press MENU one or more times to close the OSD.
To delete a memorized digital channel:
1 Tune to the channel you want to delete.
2 Press CH.LIST to open the CHANNEL LIST screen.
3 Press CH + or CH – to select SKIP, then press VOL+ to select ON.
4 Press MENU one or more times to close the OSD.
Selecting a different signal source
This TV has one group of AV input terminals, an S-VIDEO input terminal, and set of
Component input terminals to enable connection to a DVD, VCR, or other video equipment.
For information on connecting your TV to other video equipment, see "Connecting to other
equipment" on page 16.
To select a different signal source:
• Press INPUT repeatedly to cycle through the available input sources. The input sources
Tip: You can add a channel to memory by using the number buttons to enter the channel
number, then completing the steps for deleting a channel and setting the SKIP option to
OFF.
Tip: You can add a channel to memory by using the number buttons to enter the channel
number, then completing the steps for deleting a channel and setting the SKIP option to
OFF.
will be shown on the screen as they are selected.
Note: The S-VIDEO input uses the same circuit as VIDEO. If both S-VIDEO and
are connected, the S-VIDEO signal overrides the
screen. To watch the
To watch TV again, press INPUT until the TV program is shown on the screen.
VIDEO
input, disconnect the S-Video cable.
VIDEO
signal and S-VIDEO is shown on the
19
VIDEO
inputs

Advertisement

Table of Contents
loading

Table of Contents