Dell PowerVault NX300 Hardware Owner's Manual page 49

Table 1-3. System Messages (continued)
Message
The following
DIMMs should
in
match
geometry:
x,x,...
The following
DIMMs should
in rank
match
count:
x,x,...
The following
DIMMs should
match in size:
x,x,...
The following
DIMMs should
in size
match
and geometry:
x,x,...
The following
DIMMs should
in size
match
and rank count:
x,x,...
Thermal sensor
not detected
on x
Time-of-day
clock stopped
Time-of-day not
set - please run
SETUP program
Causes
Invalid memory
configuration. The specified
memory modules do not
match in size, number of
ranks, or number of
data lanes.
A memory module without a
thermal sensor is installed in
the specified memory slot.
Faulty battery or faulty chip. See "Troubleshooting the
Incorrect Time or Date
settings; faulty system
battery.
Corrective Actions
Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 115.
Replace the memory
module. See "System
Memory" on page 115.
System Battery" on page 152.
Check the Time and Date
settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 57. If the problem
persists, replace the system
battery. See "System Battery"
on page 129.
About Your System
49