Table of Contents
Advertisement
Run Cable To All Telephone Locations
Select a cable extension kit with the right length of cable (100 or 200 feet) for one cable
run. For runs over 200 feet, run a 200-foot cable, terminate it in a modular connecting
block, plug in another cable, and repeat, up to a maximum of 1000 feet.
Select a Cable Extension Kit with the right length of cable
(100 or 200 feet) for one cable run. For runs over 200 feet,
you will have to-run a 200-foot cable, terminate it in a
modular connecting block, and plug in another cable. The
maximum length of any cable run is 1000 feet.
Fill out a pair of wiring
run labels wih the
telephone location of
the first wiring run (for
example, W1 shop,
W2 sales, W3 RM. 105).
Attach one label inside
a jack panel door.
Save the second
label for use on a
modular connecting block.
Run the cable out to the telephone location. Avoid sharp
kinks or twists. Use cable clips or staples to dress the
cable neatly along wall baseboards, molding, etc. Be
careful not to damage the cable with staples.
If there is no
plastic cable
loop in place,
slide a cable tie
under the two
"spiders" in
each box.
Attach a cabel clip
6 to 12 inches
below the lowest
box to support
each cable as you
run it.
Plug in the cable
connector on the right
side. Thread the cable
through the clip.
Customer Installation Instructions
9
Advertisement
Table of Contents
