Lucent Technologies MERLIN LEGEND Release 6.0 System Programming And Maintenance Manual page 77

MERLIN LEGEND Communications System Release 6.0
System Programming and Maintenance (SPM) 555-660-140
System Programming and Maintenance
System Programming
trunk, or extension to be forced into remaining idle until programming is
completed. These procedures wait for the system, trunk, or extension to
become idle and then prevent the initiation of any new calls. This condition is
called forced idle.
NOTE:
If a procedure requires an idle condition, perform the programming
outside of normal business hours.
If a procedure requires that the system be in an idle state and the system is
busy when you begin, you see the screen shown below.
T’†‡r€Ã7ˆ†’ÃÃÃQy†ÃXhv‡
9vhyÃ8‚qr)ÃÃÃÃOOOO
Ty‚‡Q‚…‡)ÃÃÃÃTTQQ
@‘v‡
The screen changes to the appropriate programming screen when the system
is no longer busy.
System Forced Idle
When the entire system is forced idle, no calls can be made or received. The
procedures listed below can be performed only when the entire system (every
line and every extension) is idle:
Select system mode
Identify system operator positions
Renumber boards
Renumber system
Issue 1
February 1998
Page 63