Page 1
MAKING MODERN LIVING POSSIBLE FP975 7-Day Electronic Programmer Installation Guide Danfoss Heating For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk...
Page 2
Marketing on 0845 121 7400. Certification Mark Danfoss can accept no responsibility for possible errors in catalogues, brochures, and other printed material. All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Before mounting the unit, ensure the 4 DIL switches on the rear of the unit have been moved to the required settings. RIGHT LEFT FP975 For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk...
MK.9 or SET The FP975 is supplied fi tted with a Danfoss Randall SET wallplate. However the FP975 will also mount directly onto a Danfoss Randall MK.9 wallplate without the need for wiring changes. However when used with existing MK.9 wallplates the left hand switch must be set in the MK.9 position to re-confi...
Page 6
3. The FP975 off ers direct plug-in replacement to the following models (see below): FP975 For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk...
Page 7
IMPORTANT NOTE If the timeswitch to be replaced is listed below it may be worth considering a FP715 Si as an alternative to the FP975. The FP715 Si off ers wallplate compatibility for those models listed below, although some re-wiring may be required.
If the existing wallplate is of the SET pattern, follow instruction 5-9 from the “New Installations” section. • Should the existing product be a Danfoss Randall MK.9 time control the instructions below should be followed: Remove and discard the white test point cover fi tted to the top of the MK.9 wallplate.
2 x 2-port Zone Valves with Aux. Sw. PUMPED switch selection MAINS fused 3A Earths not shown. Ensure continuity throughout VALVE VALVE HEAT BOILER PLAN PUMP Danfoss Heating For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk...
See pages 12-15 WIRING CONVERSIONS to be used when replacing the following programmers with the FP975. Some time controls are connected diff erently depending on the type of system they are controlling. Consult the column headed “NOTE This conversion ... ” to determine whether Table A (pages 12-13) or Table B (pages 14-15) should be used.
Page 12
FP975 For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk...
Page 13
Danfoss Heating For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk...
Page 14
FP975 For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk...
Page 15
Danfoss Heating For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk...
Page 16
Danfoss Randall Ltd. Ampthill Road Bedford MK42 9ER Tel: 0845 1217 400 Fax: 0845 1217 515 Email: danfossrandall@danfoss.com Website: www.danfoss-randall.co.uk Part No. 8585v01s7-03 03/11 For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk...