AT&T MERLIN 1030 Installation Manual page 10

Connect the Outside Lines to the Jack Field
1
Plug the connector on the 25-pair cable into the 50-pin connector at the
network interface.
2
With a jacket-stripping tool, slit the jacket at the other end of the 25-pair
cable, and cut away as much of the jacket as necessary to allow each
of the individual twisted pairs of color-coded wires to reach the jacks
in the jack field.
3
Following the order and color code in the drawing, below, place the wires
in the terminal block grooves on the adapters.
4
Punch the wires down with a cable termination tool.
5
If your cable termination tool does not trim the wires as it punches them
down, trim the ends of the wires protruding from the grooves with a pair
of scissors.
APPARATUS BOX NO.1
APPARATUS BOX NO.2
8
APPARATUS BOX NO.3
BK = black R = red
BL = blue S = silver
BR = brown V = violet
G = green W = white
O = orange Y = yellow
APPARATUS BOX NO.4 3
1
2
4