Place An Intercom Call To A Voice Terminal; Test Each Line Number - AT&T MERLIN 1030 Installation Manual

PLACE AN INTERCOM CALL TO A VOICE TERMINAL

Make the test call from one voice terminal to another voice terminal. Have
another person available to answer the intercom call.
1
From a voice terminal, touch the fifth button down in the leftmost row
of buttons on the voice terminal (Intercom-Ring) without lifting the
handset.
The red light next to the button goes on.
2
Lift the handset.
The green light next to the button goes on.
3
Dial your partner's intercom number (a 2-digit number such as 11).
You hear an intermittent ringing.
4
Wait for your partner to answer before speaking into the handset.
When the call comes through at the called voice terminal, three short
rings sound, the red light glows steadily next to the fourth button down
in the left row of buttons (Intercom-Voice), and the corresponding green
light flashes until the handset is lifted.
5
When your partner lifts the handset at the called voice terminal, verify
two-way communication, and then hang up the handsets at both voice
terminals.
The lights on both voice terminals go out, and the red light goes on next
to the third button down in the leftmost row of buttons.
6
Repeat steps 1 through 5 for every voice terminal you want to test.

TEST EACH LINE NUMBER

Use a 34-button deluxe voice terminal at intercom 10. Have someone place calls
from another voice terminal (preferably another 34-button voice terminal).
1
Have your partner dial one of your outside line numbers.
When your voice terminal starts to ring, the green light flashes and the
red light goes on next to the appropriate line button.
If the green light flashes next to the wrong line button on the 34-button
deluxe voice terminal, make sure connections are correct between the
control unit line jacks and the network interface jacks. (For example, you
may have plugged the outside line cord into the wrong control unit Line
Module jack.)
2
Lift the handset at the answering voice terminal, verify two-way com-
munication, and then hang up the handsets at both voice terminals.
3
Repeat this procedure for each of your outside lines.
2
3
1
5
4
27