Position The Control Unit - AT&T MERLIN 1030 Installation Manual

Hide thumbs Also See for MERLIN 1030:

Table of Contents

POSITION THE CONTROL UNIT

Your control unit should be:

High enough off the floor to work with comfortably

Close enough to an ac outlet (not switch-controlled) so that a power cord

can reach easily (with some slack) from each Power Module (you may have

as many as three Power Modules) to the outlet

Within 5 feet of the jack field so that (1) a modular line cord can connect

any Line Module jack in the control unit to any jack with a green-on-white

label in the jack field, and (2) a modular jumper cord can connect any Voice

Terminal Module jack in the control unit to any jack with a blue-on-white

label in the jack field

The drawing, right, provides a diagram for positioning the control unit.

You may place the control unit on a table, a microwave oven stand, or a tele-

vision stand. Or you can order a Wall Mount Kit especially designed for wall-

mounting a Model 1030 or 3070 and follow the instructions that come with it.

NOTE: The ac outlet should be a 117-volt, 60-Hz, 3-prong, third-wire grounded

outlet. Proper grounding protects the system from damage caused by power

surges. You may want to have an electrician check the outlet's third wire to make

sure the outlet is properly grounded. Power consumption for the Model 1030

control unit is 150 watts maximum. For the Model 3070, power consumption

is 400 watts.

5 feet, maximum

Table of Contents

Merlin 3070