Section 2
2.7 Navigating the XOVER
Navigating the "X-OVER Section"
To edit the parameters of the Crossover used in a selected program, simply use the following procedure. From program mode,
either press the X-OVER button or use the Parameter 2 or 3 knobs to move to Crossover module. Once you have reached the Crossover module,
press the Parameter 2 or 3 buttons to access the editing pages of the module. Navigate through the Pages of the selected Crossover
module by pressing the "Next Page" or "Prev Page" buttons successively until arriving at the desired Page.
The X-OVER button
toggles through
the Crossover
modules used in
each channel of
the selected
program.
The PARAMETER knobs are used
to edit parameter values
DriveRack™ User Manual
18
Editing Functions
X-OVER
Filter Type
X-OVER
X-OVER
Low Fc
X-OVER
Center Fc
High Fc
X-OVER
Low1 Fc
X-OVER
Center1 Fc
High1 Fc
X-OVER
Low1 Fc
X-OVER
Center1 Fc
High1 Fc
1
Lowpass
Low Slope
Highpass
High Slope
Type
Low Slope
High Slope
Type
Type
Low2 Fc
Low1 Slope
Center2 Fc
Low2 Slope
High2 Slope
High1 Slope
High2 Fc
Low2 Fc
Type
Type
Low2 Slope
Low1 Slope
Center2 Fc
High2 Slope
High1 Slope
High2 Fc
2
3
DriveRack
Filter - Dual Filter
1X2... X-OVER
1X3... X-OVER
1X4... X-OVER
Type
Low3 Fc
Low3 Slope
Center3 Fc
High3 Fc
High3 Slope
®
™