Parameter Knob Encoders Coarse/Fine; Horizontal-Vertical Nav); Cut And Paste - dbx DriveRack 480 User Manual

Section 2
2.4 Parameter Knobs (Horizontal-Vertical Navigation Mode)
2.5 Copy/Paste Functionality
DriveRack™ User Manual
16
Editing Functions
2.3 Parameter Knob Encoders Coarse/Fine Operation
The parameter knob encoders of the 480 and 480R DriveRack™ Remote provide the user with
the option of coarse or fine performance modes. This means that the parameter knobs can be
set to either move or change values at a rapid (coarse) or slower (fine) rate. This option can
be selected in any mode by simply pressing the selected parameter knob. Successive presses
will toggle between coarse and fine mode.
The 480 DriveRack™ offers the horizontal-vertical navigation feature which helps streamline
navigation and editing of the unit. The Horizontal-Vertical Navigation mode allows the user to
use the parameter knobs (2&3) to quickly navigate through the program/configuration menu of
any DriveRack™ unit. This feature can be used to navigate the display screen in program or
configuration mode. To utilize this feature, simply select the high-lighted cursor, then use the
PARAMETER 2 knob to move the cursor left and right, and use the PARAMETER 3 knob to
move the cursor up and down while the unit is in Program or Configuration mode.
The front panel of the 480 and 480R allow you to copy and paste the parameter value settings
for entire effect module blocks, and then paste them into another block. Note that the infor-
mation from one module must be pasted into a similar module, ie; from one dynamic module
to another. This function can be performed in a single unit, or to any unit in a network setup.
The procedure for cut and paste is as follows:
• From program mode, use the PARAMETER knobs to navigate to the desired module.
• Once the desired module has been selected, press and hold the PREVIOUS PAGE button
until the display reads: COPY.
• The information is now held in what is commonly known as the "pasteboard."
• At this point, navigate to the unit that you wish to paste the information into using the
PARAMETERS knobs.
• If you are pasting into a unit within the network, either enter in the device id# (key pad on
the 480R, or from the Utility page in the 480).
• Once the desired module has been selected, press and hold the NEXT PAGE button and
the display will read: PASTE.
Select Left-Right
2
1
DriveRack
Up-Down
3
™
®