Smdi Selection; Serial Integration Configuration - Amanda Portal Field Installation Manual

If using text-to-speech or speech recognition, enter the number of licenses purchased in
the fields provided. A minimum of 2 licenses must be purchased when using text-to-
speech or speech recognition. Calls to certain area codes can be blocked using the
"Outbound call toll restrictions" by defining the area codes (this is system wide, however,
it is possible to configure toll restrictions to be mailbox specific but requires additional
configuration). Click next to continue.

3.12 SMDI Selection

If your telephone system sends SMDI for integration you should have selected the "Use
SMDI" check box on the PBX selection page. When doing so, you'll get two additional
configuration screens for SMDI. Choose the type of SMDI from the list (as shown in
figure 18). If your telephone system doesn't send SMDI integration you will not see this
or the following screen. Skip to section 3.14.
Figure 18
Click next to continue.

3.13 Serial Integration Configuration

When using serial integration (such as SMDI) you need to configure Amanda Portal to
use that call data. Configure Amanda Portal for the same data bits, data rate, stop bits,
and parity as your telephone system. Additionally, you'll need to tell Amanda Portal
which COM port to expect to receive data on. Enter the correct information (as shown in
figure 19). If your telephone system doesn't send SMDI data you will not see this or the
previous screen.
13