Mist Feature; Headlamps On With Wipers; Windshield Wiper Operation; Intermittent Wiper System - Chrysler 300C SRT8 Owner's Manual

• Use of Rain-X or products containing wax or silicone
may reduce rain sensor performance.
• The rain sensing system will not operate when the
engine is running, the gear selector is in the PARK
position, and the outside temperature is below freez-
ing. This is done to protect the wiper blades from
damage. Place the gear selector in the DRIVE position
to allow the rain sensing feature to operate.
• A customer programmable feature in the Electronic
Vehicle Information Center (EVIC) allows the Rain
Sense feature to be turned off. Refer to "Personal
Settings" in the Electronic Vehicle Information Center
section of this manual for details.

Mist Feature

Push the wiper lever in to activate a single wipe to clear
off road mist or spray from a passing vehicle. As long as
the lever is pushed in, the wipers will continue to
operate.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 103

Headlamps On With Wipers

The headlights will turn on approximately 10 seconds
after the wipers are turned on if the headlight switch is
placed in the AUTO position. The headlights will also
turn off when the wipers are turned off if they were
turned on by this feature. This feature can be turned on or
off using the Electronic Vehicle Information Center
(EVIC). Refer to "Headlamps On With Wipers" in the
Electronic Vehicle Information Center section of this
manual for details.

Windshield Wiper Operation

Rotate the end of the lever to the second detent for Low
speed wiper operation, or to the third detent for High
speed operation.

Intermittent Wiper System

Use the intermittent wiper when weather conditions
make a single wiping cycle, with a variable pause be-
tween cycles, desirable. Rotate the end of the lever to the
first detent position, then turn the end of the lever to
select the desired delay interval. There are 6 possible
3