Windshield Washers; Wiper Operation; Mist Feature - Chrysler 2015 300 SRT Operating Information Manual

Hide thumbs Also See for 2015 300 SRT:
Table of Contents

Advertisement

pause between cycles desirable. Rotate the
end of the multifunction lever to the first detent
position, and then turn the end of the lever to
select the desired delay interval. There are four
delay settings, which allow you to regulate the
wipe interval from a minimum of one cycle every
second to a maximum of approximately 36
seconds between cycles. The delay intervals
will double in duration when the vehicle speed is
10 mph (16 km/h) or less.

Wiper Operation

Rotate the end of the multifunction lever to the
first detent, past the intermittent settings for
low-speed wiper operation, or to the second
detent past the intermittent settings for high-
speed wiper operation.
CAUTION!
• Turn the windshield wipers off when driv-
ing through an automatic car wash. Dam-
age to the windshield wipers may result if
the wiper control is left in any position
other than off.
CAUTION! (Continued)
• In cold weather, always turn off the wiper
switch and allow the wipers to return to the
"Park" position before turning off the en-
gine. If the wiper switch is left on and the
wipers freeze to the windshield, damage to
the wiper motor may occur when the ve-
hicle is restarted.
• Always remove any buildup of snow that
prevents the windshield wiper blades from
returning to the off position. If the wind-
shield wiper control is turned off and the
blades cannot return to the off position,
damage to the wiper motor may occur.

Mist Feature

Rotate the end of the lever downward to the
Mist position to activate a single wipe cycle to
clear off road mist or spray from a passing
vehicle. The wipers will continue to operate until
you release the multifunction lever.
(Continued)
NOTE:
The mist feature does not activate the
washer pump; therefore, no washer fluid will
be sprayed on the windshield. The wash
function must be used in order to spray the
windshield with washer fluid.

Windshield Washers

To use the washer, push the multifunction lever
inward (toward the steering column) and hold it
for as long as washer spray is desired.
If you activate the washer while the windshield
wiper control is in the delay range, the wipers
will operate for two wipe cycles after releasing
the lever and then resume the intermittent inter-
val previously selected.
If you activate the washer while the windshield
wiper is turned off, the wipers will operate for
three wipe cycles and then turn off.
WARNING!
Sudden loss of visibility through the wind-
shield could lead to a collision. You might not
(Continued)
89

Advertisement

Table of Contents
loading

Table of Contents