General Information - Chrysler 300C SRT8 Owner's Manual

Hide thumbs Also See for 300C SRT8:
Table of Contents

Advertisement

216 STARTING AND OPERATING
warning will reset automatically when the vehicle has
been driven for at least 2 minutes at or above 15 mph (24
km/h).
CHECK TPM SYSTEM
See your authorized dealer when this message appears in
the EVIC. This message indicates that a system fault
condition has been detected.
CAUTION!
The TPM system has been optimized for the original
equipment tires and wheels. TPM system pressures
have been established for the tire size equipped on
your vehicle. Undesirable system operation or sen-
sor damage may result when using replacement
equipment that is not of the same size, type, and/or
style. After-market wheels can cause sensor damage.
Do not use tire sealant from a can, or balance beads
if your vehicle is equipped with a TPM system, as
damage to the sensors may result.
CAUTION!
After inspecting or adjusting the tire pressure al-
ways reinstall the valve stem cap. This will prevent
moisture and dirt from entering the valve stem,
which could damage the wheel rim sensor.
NOTE:
• The TPM system can inform the driver of a low tire
pressure condition.
• The TPM system is not intended to replace normal tire
care and maintenance, nor to provide warning of a tire
failure or condition.
• The TPM system should not be used as a tire pressure
gauge while adjusting your tire pressure.

General Information

This device complies with part 15 of the FCC rules and
RSS 210 of Industry Canada. Operation is subject to the
following conditions:
• This device may not cause harmful interference.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents