Reprogramming A Single Homelink Button; Security - Chrysler 300C SRT8 Owner's Manual

in the train (or learning) mode and can be pro-
grammed at any time beginning with Programming
- step 2.

Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. Do
NOT release the button.
2. The EVIC display will show "Channel X Transmit"
(where X is Channel 1, 2, or 3) for 20 seconds and then
change to "Channel X Training". Without releasing the
HomeLink button, proceed with Programming step 2.
For questions or comments, contact HomeLink at:
www.homelink.com or 1-800-355-3515.

Security

If you sell your vehicle, be sure to erase the frequencies
by following the "Erasing HomeLink Buttons" instruc-
tions in this section.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 119
This device complies with part 15 of FCC rules and with
RSS-210 of Industry Canada. Operation is subject to the
following conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may be
received including interference that may cause undes-
ired operation.
NOTE: Changes or modifications not expressly ap-
proved by the party responsible for compliance could
void the user's authority to operate the equipment.
HomeLink is a trademark owned by Johnson Controls,
Inc.
3