At The End Of A Wash Programme; Continuous Wash-Dry Cycle - Baumatic BWD12 Instruction Manual

At the end of a Wash Programme

NOTE : YOU CAN ONLY SET YOUR APPLIANCE TO WASH
AND DRY A WASHLOAD BEFORE A WASHING CYCLE IF YOU
HAVE SET A HALF LOAD PROGRAMME AND ARE WASHING
A HALF LOAD OF LAUNDRY. YOU CANNOT DEFEAT THIS
RESTRICTION BY PLACING A FULL LOAD AND SELECTING
THE HALF LOAD BUTTON.
Provided the programme completes without interruptions, you can
open the loading door 2 minutes after it has completed. Take
out your clothes. If you have just washed a full load, take
out half of the laundry in the drum if you intend to use a
drying cycle, being mindful of the fabric type/s you are
about to dry.

CONTINUOUS WASH-DRY CYCLE

This feature of your appliance allows a drying cycle to follow
on from a washing cycle without your having to go
anywhere near your washer-dryer!
NOTE: You will need to set your washer-dryer to
perform this function if you do not want it to wash
and stop and then have to dry separately.
Set your washing programme as you would normally, but
REMEMBER THAT YOU MUST SELECT THE HALF-LOAD
FEATURE.
Set your drying timer as you would normally do for a
drying programme.
Bear the following in mind when setting this function
• Set the drying time
using the timer knob,
remembering that
21
several short spells
are better than a long
pre-programmed one.