Assembly Instructions - Axminster TS-200 User Manual

Initial Assembly
Please take some time to read the section entitled "Identification and Parts Description" to
identify the various parts of your machine so that you are familiar with the terminology we
will use to enable you to set up and operate your table saw safely and correctly.
Assembling the stand (Kits: 700059, 718641)
Locate and identify the 4 legs (P), the short struts (R)
and the long struts (Q) for the stand, and the packet
containing 32 M8 x 10mm coach bolts, washers and
nuts.(T).
Using the M8 x 10mm coach bolts, nuts and washers
bolt together two 'A' frames using two legs (P) one long
strut (R) in the middle and one short strut (Q) at the
top. Tighten the nuts only 'finger tight' at this time.
(See fig 1).
When the two 'A' frames have been assembled,
select one, turn it upside down on a flat surface and
loosely bolt the 'short strut' (R) and long strut (Q) in
place (See fig 2). Attach the other "A' frame and bolt the
remaining struts for the other side.
When all the components are assembled, using the flat
surface as a reference, tighten up all the nuts. Turn the
stand on it's side and place the four rubber feet (S) to
the ends of the 'A' frames. Upright the frame and stand
on the floor. (See fig 3).
S
Fig 3

Assembly Instructions...

Fig 1
Q
R
Q
W
A X M I N S T E R
W H I T E
P
R
Fig 2
10