Axminster TS-200 User Manual page 16

Assembly Instructions...
W
A X M I N S T E R
W H I T E
Fig 26
Operating Wheel Handles Assembly (Kits: 950650, 718641)
Locate the two operating wheel handles (F) and, using the supplied 3mm allen key (J),
secure one to the tilt mechanism shaft to the front of the saw by undoing the grub screw on
the operating wheel handle (F) and sliding it onto the shaft, making sure the grub screw is
in line with machined slot (a), in the shaft. Retighten the grub screw. Repeat for the height
mechanism to the right hand side of the saw. (See figs 27 & 28).
Fig 28
Height operating wheel handle
Saw Guard Assembly (Kits: 950650, 718641)
Find the saw guard (U) (you will require a 10mm socket), undo the M6 nut and remove
the M6 coach bolt. Slot the saw guard over the riving knife and line up the pre-drilled hole in
the riving knife and replace the M6 coach bolt & nut and tighten. (DO NOT OVERTIGHTEN)
(See fig 29).
Extension Table Assembly Part 1 (Kits: 700058, 950650 718641)
NOTE: KIT 950650 COMES WITH THE FENCE SUPPORTING ARM ONLY AND DOES
NOT INCLUDE THE BACK SUPPORTING ARM.
Put to hand six M6 x 25mm Phillip head screws with nuts (Z3), remove the nuts and place
the screws into the three holes to the front and rear of the main table. Replace the nuts.
(Note: Leave a gap between the base of the table and nut) (See figs 30 & 31).
Fig 30
15
Continues on next page....
Z3
J
a
Tilt operating wheel handle
U
M6 x 25mm Phillip head screw & nut
Fig 27
F
Fig 29
Fig 31