Configuration Steps - 3Com Dual 56K User Manual

48 C 5: C
HAPTER ONFIGURING THE
Configuration Steps
D 56K LAN M
UAL ODEM FOR
In addition, you should have the following information ready as you go through
the configuration:
Your Analog Telephone Number or Numbers
ISP Telephone Number
ISP User ID and Password
ISP DNS Address (required only if your ISP does not use dynamic IP
addressing)
(Optional) Call Waiting Disable Command (your telephone company can
provide you with this value)
The following steps guide you through configuration of the Dual 56K LAN Modem
for shared Internet access.
If you ran the computer pre-checks in Chapter 3 and found that your computer
was set up for static IP addressing, and you chose to follow the manual setup
procedure for Static IP addressing, (as opposed to using the EZ-LAN Wizard, as
described in the Getting Started Guide) refer to the section "Changing the LAN
Modem IP Address for Static IP Users" on page 52 once you have completed these
initial configuration steps.
1 Launch the Web browser on the computer that you attached to the LAN Modem
during the installation.
Regardless of the start page to which your Web browser is set, your Web browser
will go to the Dual 56K LAN Modem's initial configuration welcome window.
A welcome message appears, as shown in Figure 30.
Figure 30 Initial Configuration Welcome Window
2 Click the Continue link.
A message box appears indicating that the LAN Modem clock is being
synchronized to the date and time on your computer.
I A
NTERNET CCESS