3Com Dual 56K User Manual page 45

5 Connect the power supply to the back of the unit, as shown in Figure 28.
Figure 28 Power Cable Connection
6 Plug the other end of the power module into a surge-protected, standard wall
outlet, and watch for the following front panel LED signals:
The PWR and AA indicator LEDs light up.
The ALERT LED flashes momentarily as the unit undergoes a power-up, self-test
diagnostic.
After the diagnostic test has been completed, only the PWR LED remains lit.
7 Turn on your workstation.
Watch for the LAN Status LED to flash and then remain lit.
This completes the Dual 56K LAN Modem installation. You are ready to go on to
Chapter 5 to configure the LAN Modem for shared access to the Internet. Or, if
you wish to configure the LAN Modem for shared dial-out access to a Private
Network, such as a remote corporate office LAN, refer to Chapter 6. To configure
the LAN Modem for dial-in support, refer to Chapter 8.
If the installation was not successful, refer to Chapter 10, "Troubleshooting and
Maintenance."
T
S E
R E
C
V D
X
1 8 5
1 0 - M A
8 A
0 ¥
6
MODEM 1 MODEM 2
d e m
M o
L A N
6 k
a l 5
D u
n e ct
C o n
ic e
O ff
Before You Start the Installation
P
E 2
L I N
E 1
O N
P H
2
E 1
L I N
4
1
N
3 L A
LAN Status
OfficeConnect Dual 56k LAN Modem
45