Alarm Lock INSIDE BATTERY KIT Installation Instructions

345 Bayview Avenue
Amityville, New York 11701
For Sales and Repairs 1-800-ALA-LOCK
For Technical Service 1-800-645-9440
Some installations require the batteries powering the door lock be placed inside the protected premises. The following in-
structions describe how to install the Inside Battery Kit for your narrow stile door lock.
Battery Cover
Screw
1. Loosen the battery cover screw
and slide the battery cover off the
lock.
Set Screw
5. Deadbolt models only: Loosen
the interface cylinder set screw
(skip this step for springlatch
models).
9. Use a #21 drill for
both the bottom
Bracket hole
(shown), and the
Center Oval
center oval.
Bottom
Bracket Hole
Battery Pack Connector
13. With the Rear Cover Plate
separated from the lock body,
find and disconnect the Battery
Pack Connector.
INSIDE BATTERY KIT

INSTALLATION INSTRUCTIONS

© ALARM LOCK 2006
Publicly traded on NASDAQ Symbol: NSSC
Decorative door
plate covers
2. Remove the decorative door
plate covers by sliding them up
from the door plates.
6. Remove lock from door.
10. Enlarge the center
oval hole to 7/16".
This center oval hole
is the only hole that
Enlarge to 7/16"
must be drilled all the
way through the
door.
Note: Remove the
Battery Mounting
Bracket before
enlarging this hole.
Glue
Glue
14. Battery Pack Connector wire is
glued in two locations (shown).
Carefully lift and remove wire from
glue to detach.
www.alarmlock.com
Door Plate
3. Unscrew four through-door
mounting screws (in two door
plates) that secure the lock to the
door.
7. Secure the Bat-
tery Mounting
Bracket using the
top door mount-
ing screw that is
located away
from the edge of
the door.
11. Tap #10-32 threads into the bot-
tom Bracket hole drilled in step 9.
Now the lock's Rear Cover Plate
must be removed, as shown in step
12:
Align the
Engager pin
and the
Driver hole
15. Replace the Rear Cover Plate.
Route the Battery Connector Wire
through the correct hole as shown
in step 16.
WI1516 2/06
4. Remove Latch
Face Plate.
8. Using a center-
punch, mark two
holes for drilling:
• Mark the bottom
Bracket hole for
securing the
Mark
Mounting Bracket
here
(shown)
--and--
Mark in the center
•
oval for routing the
remote battery
wires.
12. Remove the flat-head mounting
screws located at both ends of the
lock.
Battery
Connector
Wire
16. Make sure the Battery Connec-
tor Wire is routed through the
correct hole to meet up with the
center oval hole drilled in step 10.
continued