Agilent Technologies U1401B User's Manual And Service Manual page 59

U1401B User's and Service Guide
used to indicate the start or end position. The last three
digits of the primary display are used to indicate the
number of steps (the number of steps from start to end).
1 Press MODE to cycle through position (start or end),
number of steps, and amplitude adjustment. The digit to
be adjusted will flash on the display.
• For adjusting the amplitude, to adjust the value of the
selected digit. The amplitude can be set to any value
within the selected output range (±1.5 V or ±15 V for
constant voltage output, ±25 mA for constant current
output).
• For adjusting the number of steps, press
select the digit to be adjusted, then press
to adjust the value of the selected digit. The number of
steps can be set within the range of 0 to 999 steps.
• Press for more than one second to directly reset
the time interval and amplitude of the present step to
zero.
2 Press OUTPUT to save the settings.
Calibrator Output Operations
and
2
to
and
39