Chapter 5. Installing Options; Before You Begin; System Reliability Considerations; Handling Static-Sensitive Devices - IBM 620410U - IntelliStation E - Pro 6204 User Manual

Chapter 5. Installing options

This chapter provides instructions to help you install or replace options on your
computer. For a list of supported options for your computer, go to
http://www.ibm.com/pc/support/ on the World Wide Web.

Before you begin

Before you begin to install options in your computer, read the following information:
v Read the handling guidelines in "Handling static-sensitive devices", and read the
v Make sure that you have an adequate number of properly grounded electrical
v Back up all important data before you make changes to disk drives.
v Have a small, flat-blade screwdriver available.
v Before accessing the inside of the tower model computer, rotate the two front
v For a list of supported options for your computer, go to

System reliability considerations

To help ensure proper system cooling and system reliability, make sure that:
v Each of the drive bays has a drive or a filler panel and electromagnetic
v There is adequate space around the computer to allow the computer cooling
v You have followed the instructions for cabling provided with optional adapters.
v You have replaced a failed fan as soon as possible.

Handling static-sensitive devices

Attention: Static electricity can damage electronic devices, including your
computer. To avoid damage, keep static-sensitive devices in their static protective
bag until you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions.
v Limit your movement. Movement can cause static electricity to build up around
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and, possibly, damage the
© Copyright IBM Corp. 2002
safety statements in "Safety information" on page vii. These guidelines will help
you work safely with your computer and options.
outlets for your computer, monitor, and other options that you intend to install.
stabilizing feet a quarter turn in towards the computer, so they do not break.
Before placing the computer in an upright position, rotate the two front feet a
quarter turn outward from the computer. See "Moving the stabilizing feet" on
page 12.
http://www.ibm.com/pc/support/ on the World Wide Web.
compatibility (EMC) shield installed.
system to work properly. Leave approximately 51 mm (2 in.) of open space
around the front and rear of the computer. Do not place objects in front of the
fans.
you.
device.
39