IBM 620410U - IntelliStation E - Pro 6204 User Manual page 80

Installing an adapter: Do the following to install an adapter in the tower model:
Attention:
damage from static electricity. For details on handling these devices, see "Handling
static-sensitive devices" on page 39.
64
IBM IntelliStation E Pro Types 6204 and 6214: User's Guide
When you handle static-sensitive devices, take precautions to avoid
1. Review the information in "Safety information" on page vii.
2. Turn off the computer and all attached devices.
3. Disconnect all external cables and power cords; then remove the side cover.
See "Removing the side cover" on page 60.
4. Determine which PCI slot you will use for the adapter.
Note: Check the instructions that come with the adapter for any requirements,
restrictions, or cabling instructions. It might be easier to route any
cables before you install the adapter.
5. For full-length adapters, rotate the rear adapter-retention bracket to the open
(unlocked) position and remove it from the computer. Rotate the front
adapter-retention bracket to the open position. If you are installing a smaller
adapter, remove only the rear adapter-retention bracket.
6. Remove the expansion-slot cover. From the rear of the computer, press on the
slot cover. Grasp it and pull it out of the expansion slot. Store it in a safe place
for future use.
Attention: Expansion-slot covers must be installed on all vacant slots. This
maintains the electronic emissions standards of the computer and ensures
proper ventilation of computer components.
7. Set any jumpers or switches on the adapter or system board as described by
the adapter manufacturer.