Ei Electronics RadioLINK Ei200MRF Instructions Manual page 4

fold over House
pull tag Code Button
Blue
Light
Antenna
Figure 1 Figure 2
4. Twist the Alarm onto its mounting plate.
5. Similarly press and hold the House Code button on the second Alarm until its
blue light comes on and then release. Twist the Alarm onto its mounting plate.
Put all the remaining Alarms into House Code mode similarly and attach to the
mounting plate in the same manner in less than 15 minutes. (They automatically
exit house code mode after 30 minutes).
6. When in the House Code mode, the blue light (on the front of the Alarm - see
figure 3) will flash a number of times every 5 seconds to indicate:
(a) that the Alarm is in House Code mode, and
(b) the number of Alarms that have been identified and added to your system.
4