Troubleshooting; Cannot Connect To A Paired Device; Cannot Discover Services On An Un-Paired Remote Device; Dial-Up Networking Service Does Not Start - Acer BT-800 User Manual

Acer Bluetooth 1.2 USB Dongle User's Manual

8 Troubleshooting

8.1 C
ANNOT CONNECT TO A PAIRED DEVICE
Paired devices are always displayed in My Bluetooth Places, even if the remote device is
out of range or not powered up.
Verify that the remote member of the pair is within radio range, and powered up, and then
attempt the connection again.
8.2 C
ANNOT DISCOVER SERVICES ON AN UN
The remote device may not be powered up or may be out of range.
•
Verify that the remote device is powered up.
•
Verify that the remote device is in Connectable mode (Bluetooth Configuration
Panel > Accessibility tab).
•
Perform a Search for Devices to verify that the device is within range.
8.3 D - N
IAL UP ETWORKING SERVICE DOES NOT START
The Dial-up Networking service will not start unless a properly configured modem is
attached to the server.
•
Verify that the modem is usable as a local device on the computer to which it is
attached.
In the Bluetooth Configuration Panel, Local Services tab, double-click the
Dial-up Networking service:
Click the down arrow in the Modem field and select the modem that will be
used to dial out
Click the OK button
Click the OK button to close the Bluetooth Configuration Panel.
8.4 D
ETERMINE THE
DEVICE
In the Bluetooth Configuration Panel, on the Hardware tab, in the Devices section, select
the device you want to determine the address of. In the Device Properties section of the
dialog box, the fourth entry, Device Address, is the BDA of the selected Bluetooth device.
8.5 D
ETERMINE THE VERSION OF THE
In the Bluetooth Configuration Panel, on the Hardware tab, in the Device Properties
section, the fifth entry provides Bluetooth Specification compliance information for the
Host Controller Interface.
The sixth entry contains the Specification Revision information for the Host Controller
Interface, if appropriate.
8.6 D
ETERMINE THE VERSION OF THE
In the Bluetooth Configuration Panel, on the Hardware tab, in the Device Properties
section, the seventh entry provides Link Manager Protocol version number information.
The eighth entry contains the Link Manager Protocol sub-version number information, if
appropriate.
8.7 F
IND INFORMATION ABOUT THE
COMPUTER
B D
LUETOOTH EVICE
H
OST
L
INK
B
LUETOOTH HARDWARE ATTACHED TO MY
-
PAIRED REMOTE DEVICE
A (BDA)
DDRESS OF MY HARDWARE
C I
ONTROLLER NTERFACE
M P
ANAGER ROTOCOL
(HCI)
(LMP)
52