Drivers Required; Installation Tips - Acer Altos R720 Installation & Configuration Manual

Altos R720 Installation Configuration Guide
NetWare Loadable Modules:
Please press INSERT key to insert the onboard Intel 82563EB Gigabit
10.
Ethernet driver. After the drivers are successfully loaded, please select
Return to driver summary.
Then, you would see the following message. Please select Continue.
11.
The following device drivers were detected for this
server. Add, change, or delete device drivers as
needed.
Device types
-------------------------
Network boards:
Network Loadable Modules:
Please follow the normal procedures to complete the NetWare 6.5
12.
installation.
NetWare 6.5 SP5 Installation (with integrated SAS hardware
RAID 2)
Below information describes how to manually install NetWare 6.5 (Support
Pack 5 overlay CD) on Altos R720 with integrated SAS hardware RAID 2.

Drivers Required

For NetWare 6.5 SP5 installation with integrated SAS hardware RAID 2, the
following device drivers are required.
Device
Integrated SAS
hardware RAID 2
Onboard Chipset
Onboard Gigabit
Ethernet
Onboard VGA
Onboard USB 2.0

Installation Tips

NOTE. You need to apply the integrated SAS hardware RAID 2 and NIC driver
during the installation. If you do not have the optional internal USB floppy
drive, you need an external USB floppy drive.
Make a driver diskette for integrated SAS hardware RAID 2 and onboard
1.
Intel 82563EB Gigabit Ethernet from EasyBUILD 7.1 build 100.
Boot the system from the NetWare 6.5 SP5 OS CD.
2.
At Welcome to the NetWare 6.5 server installation page, select Manual to
3.
86
(optional)
Driver names
--------------
E1000E, E1000E
(optional)
Version EasyBUILD Version
1.04.04 EasyBUILD 8.0 build 200 (or later)
N/A OS built-in
10.45 EasyBUILD 8.0 build 200 (or later)
N/A OS built-in
N/A OS built-in