2.2 PT Programming—Procedures
[913] Call Waiting Caller ID Assignment
Enables the Call Waiting Caller ID feature for each outside (CO) line that has had Caller ID Service
contracted from the telephone company.
9
1
3
Conditions
•
When the Caller ID feature is disabled in [900] Caller ID, the Call Waiting Caller ID feature does
not function even if it is enabled here.
Programming Manual References
[900] Caller ID
Feature Manual References
1.1.28 Call Waiting Caller ID
[914] Call Waiting Caller ID CAS Receive Time
Selects the allowable CAS (CPE [Customer Premise Equipment] Alerting Signal) duration. Normally, it
should not be necessary to change the default setting.
If the extension user has a Call Waiting Caller ID during a conversation, the telephone company will send
an alert tone (CAS) to the PBX. If the CAS duration is too long or too short, the CAS is ignored by the PBX.
If the CAS is accepted, then the PBX will respond and the Call Waiting Caller ID feature will be performed.
9
1
4
Conditions
•
This program is available when the Caller ID and Call Waiting Caller ID features are enabled in
[900] Caller ID and [913] Call Waiting Caller ID Assignment.
Programming Manual References
[900] Caller ID
[913] Call Waiting Caller ID Assignment
Feature Manual References
1.1.28 Call Waiting Caller ID
76
Programming Manual
NEXT
CO line no.
NEXT
(1 ... 8/
)
NEXT
SELECT
STORE
(Mode 1: 40-120 ms/
Mode 2: 64-96 ms
Mode 3: 72-96 ms)
or
PREV
To continue
SELECT
STORE
( Enable/
To continue
Disable)
SELECT
END
END