CPC Signal Detection—Outgoing
Enables the PBX to detect a CPC signal from outgoing outside (CO) line calls. If disabled, CPC signal
detection is only activated during an incoming outside (CO) line call.
Default
All outside (CO) lines: Off
Value Range
On (checked), Off (unchecked)
Programming Manual References
[421] CPC Signal Detection—Outgoing
Feature Manual References
1.1.31 Calling Party Control (CPC) Signal Detection
Disconnect Time
Selects the length of the disconnect signal sent from the PBX to the telephone company or host PBX. The
time you select must be longer than the requirements of your telephone company or host PBX.
Default
All outside (CO) lines: 1.5 s
Value Range
0.5 s, 1.5 s, 4.0 s
Programming Manual References
[422] Disconnect Time
Feature Manual References
1.1.60 Flash/Recall
Ring Tone Pattern
Selects the ring tone pattern for incoming outside (CO) line calls. It is recommended that you set a different
ring tone pattern from the ring tone patterns specified in Extension—Ring Tone Pattern on the 9.1.11
Detail [1-10] screen and Doorphone Ring Tone Pattern—Door 1–4 on the 9.7.2 Others [7-2] screen.
Default
All outside (CO) lines: Single
Value Range
Single, Double, Triple
Programming Manual References
[423] CO Line Ring Tone Pattern
9.1.11 Detail [1-10]—Extension—Ring Tone Pattern
9.3 CO [3]
Programming Manual
187